Our Products

Replacement Valve & Seal Kit (2 of each)

$8.00

NOT AVAILABLE IN NEW ZEALAND

KIT CONTAINS 2 X REPLACEMENT RUBBER SEALS PLUS 2 X CENTRE SILICONE VALVES

Replacement Grey Rubber Seals are the rear surface seals between your suction cup and the wall. They prevent air entering into the suction cup which causes the suction to fall off the wall. Although they are manufactured from a high density rubber they may need to be replaced if they become damaged from cleaning agents or misuse.

The replacement grey rubber seals are suitable for both for the Fusion-Loc and EvoVac square suction cups and they come as a pair.

Installation Guide

1. Remove the old rubber seals and dispose.
2. Clean the suction cup with warm water and allow to air dry.
3. Inspect the new rubber seal and ensure the side with the cut away channel is not stuck together, if it is then un-stick the edges with your finger by separating the sides of the channel.
4. Install the rubber seal channel side down ensure that the groove is pushed all the way down into the suction cup so that only approximately 1mm of the rubber seal is protruding from the suction cup.

Why are our suction cups the best on the market? Read our BLOG HERE

SKU: 44SP13 Category:

Description

NOT AVAILABLE IN NEW ZEALAND

KIT CONTAINS 2 X REPLACEMENT RUBBER SEALS PLUS 2 X CENTRE SILICONE VALVES

Replacement Grey Rubber Seals are the rear surface seals between your suction cup and the wall. They prevent air entering into the suction cup which causes the suction to fall off the wall. Although they are manufactured from a high density rubber they may need to be replaced if they become damaged from cleaning agents or misuse.

The replacement grey rubber seals are suitable for both for the Fusion-Loc and EvoVac square suction cups and they come as a pair.

Installation Guide

1. Remove the old rubber seals and dispose.
2. Clean the suction cup with warm water and allow to air dry.
3. Inspect the new rubber seal and ensure the side with the cut away channel is not stuck together, if it is then un-stick the edges with your finger by separating the sides of the channel.
4. Install the rubber seal channel side down ensure that the groove is pushed all the way down into the suction cup so that only approximately 1mm of the rubber seal is protruding from the suction cup.

Why are our suction cups the best on the market? Read our BLOG HERE